Bottom Wing Skins (Left) 20-4-4, 20-4-6
To finish out the left wing before moving it to the wing cradle, I attached the flap gap fairing that I had previously prepared. These rivets were mostly squeezed with the exception of one bucked rivet and an MSP-42 rivet in the same locations as on the right wing.
Unfortunately, I could not attach the aileron gap fairing as I had previously damaged it and will be getting a replacement.
 |
| Rear spar doubler holes countersunk for an AN4 rivet |
With the flap gap fairing riveted on, I moved the left wing assembly into the wing cradle to make space for working on other build sections.
 |
| Both wing assemblies in the wing cradle with additional wood blocks clamped at the inboard ends to prevent accidental sliding |
 |
| While the wing structures are mostly complete, there is a lot of work still to be done on the inside for wiring, trim and autopilot servos, pitot tube, and aileron actuation |
Time Taken: 2.5 hours
Dates: June 25 - June 30 2024
Bottom Wing Skins Total Time: 8.9 hours
RV-10 Build Total Time: 742.2 hours
Priming Total Time: 83.6 hours (not included in build time totals)